3200 error code will not clear

[Stayouttadabunker]

Is the green wire from the hopper optics gong to the ground?
Run the hopper <3> test again until it spits out 10 coins and stops every time.
If not, then you have to wait until the new optics come in.

In Reply #3 you said the hopper <3> test worked spitting out 10 coins,  but by Reply #12, it's a runaway hopper.
I hope by hooking them up wrong, you only burned out the hopper optics , not anything on the MPU.

[rlebida]

Thanks for your reply could you tell me what was hooked up wrong the ground from the optics goes to the ground on the base of the hopper.

[Stayouttadabunker]

Not really, we're still waiting for some pictures, you've said you were going to post.

The green wire from the optics goes to the grounding bolt on the hopper chassis.
Did you cross the yellow and red wires at any point?

Check the hopper optics with a multimeter to see if they're any good.
If they are good, then the problem goes further back.
You next step would be to check for continuity between the optics and the 3 other points at the other end of the wiring.
See if there's a break in the wiring underneath the covering.
Then, check if you have them hooked up to the beau plug on the correct pins.
Get out your multimeter & camera.

[rlebida]

Ok friends this has been solved replaced coin optics with no luck then I replaced the hopper and now it Works perfect.

[Stayouttadabunker]

yAY! I'm glad you had another hopper to try!