Cabinet screws

[ianmcneil68]

Anyone know the size/thread pitch of the screws and nuts for mounting boards, brackets and what not inside the cabinet? I am going to need extras.

[Amechanic]

Well first off you didn't say what your working on, but since your in the S2000 area it must ber the IGT S2000... I'm not very good when it comes to metric sizes and thread pitches. What I do is take some hardware to my local Ace hardware or just about any hardware store. In the aisle where they sell this stuff they usually have a thread gauge setup where you can try your parts for size. Then just go looking in the metric parts drawers for your pieces you want or need.. This is how I have had to do it in the past..

[ianmcneil68]

Yes,  I thought of that. I've got a good old school hardware store not to far away. I just figured I'd ask in case someone knew. I tend to order a lot online so I don't have to hassle with it. I'll do that if it comes down to it. Thanks.

[therockinelvis]

Ace is the Place. They will be metric like m2 or m3 I think. Drop by and figure it out then order a thousand online. haha. I bought an assortment at Harbor Freight and had several I can use.
 

[ianmcneil68]

Perfect. I'll do it. Thank you, sir!