Proper version chip for multi denom?

[br549autosales]

I'm about to set one of my S2000 machines up for multi denom, do I use a VS011GX1 or a VSO11NX5? it's been a few years since I set one up

[sixcardmark]

Both are multi-denom.  NX5 was meant for NJ only.

[br549autosales]

Ok thanks

[br549autosales]

Well I have more of the NX5 ones, so I'll use it, thanks

[br549autosales]

Ok I set this game up with the NX5 version chip and set my denom to .50, my coin denom to .50 and my other denims to 1.00, 2.00 and 5.00. Enabled button 1,2,3,4 and player percentage to 98% on all 4. Now I don't have a 4 button denim touch panel in this game, I was going to use the far right change button to select which denomination. Now when I rebooted the game after setting all the settings it's showing .50, 1.00, 2.00, 5.00 in the left display but it stays set on .50 and I can't change to the other 3 denims by pressing the change button on the right side. Did I miss a step in the set up process possibly? For some reason I could not get the printer to enable either, I can probably live without the printer though

[br549autosales]

Nevermind, for some reason the black ground wire was not on the switch, I got it now. Any idea why the printer won't enable? It won't respond in the auto configure nexplex devices either. I took off the top glass to look at the printer and there is paper in it but the green LED on the left is blinking.  I try to feed the tickets in and it does not auto feed the ticket

[br549autosales]

Looks as if it has power, green LED blinking but but it won't auto feed the ticket when I try to feed it in

[sixcardmark]

Check 7.2.2.1 or whatever it is and see if it is enabled.

[br549autosales]

It's disabled right now but it would not allow enable when I tried to enable it in the s previously ettings