s2000 main wire harness

[scratchee35]

i am still needing this harness...i have pulled it out of my machine and tested in an different machine, and it does work, altho i really dont want to continue to use it...the only tab i found on the harness is 60754003-B   HK/12/03...also, not sure if this makes a difference but it is for an Enhanced board and uses an R board for the game installed


still not able to figure out why the machine quit working, but im still working on that too....

any help or suggestions is very much appreciated

thanks!!!

Steve

tried to post this 2 other times, both with pictures but get "fatal error" message,...gonna try to send without pic this time....

i need the main wire harness from power supply to the motherboard for my s2000...power supply must have been loose at the casino for quite a while..lots of arcing damage in both the supply and harness...after tightening, the machine powered up, i was able to do a boot clear and setup, even took my 100...then nothing..down it went..only thing on is the door light

im gonna replace the harness and supply and see where that leads me...any other ideas?

thanks!!!

Steve

[qbert]

Sounds like you have located the problem.
While you are waiting for parts you may want to try unplugging the power to each of the florescent ballast (3) as a bad one will give you the same problem.

Rich

[scratchee35]

this machine has a bonus on the top, and i found like 3 ballasts on the top also...plus the 3 down below...unfortunately, im getting the same result...nothing but the door light on...

i appreciate the suggestion as ive never had this issue before and didnt know that a ballast would cause an issue like this....any others would be very helpful!!!

thanks again!!!

Steve