Country Party sounds eproms

[FuzzyDise79]

I was wondering if anyone could lend advise or point me in the right direction. i have a "rom sound 0" error on a Country party machine. i did remove checked the pins and replaced them no change. i was hoping that someone could put me in touch with sombody or a vendor that could replace or write a new set of roms to fix my machine if one of more or mine are bad.

Thanks Lester

[playklax01]

Did you recently change the ROMs/game?  Have they worked before?  Before you assume the ROMs are bad, is JP2 in the correct position? 

[dragster73]

The ROMs your looking for are for the WMS dotmation game? Do you have the ability to burn your own Eproms?

[FuzzyDise79]

Thanks for the responses. please pardon my ignorance in this i am new to this.  sorry for the lack of details in the initial post i was trying to keep it brief.  Playlax01 to my knowledge they are the original Roms, they had worked prior to the cabinet being moved and me acquiring the machine. i did check the JP2 Pin placement per suggestions i found browsing on this forum i believe it is in the correct position. i get the test bong on startup then 1 fault chirp right after. with the "rom sound 0" display.    Dragster73 i do not have the ability to test or write my own Eproms at this point i am not opposed to getting the equipment if needed i would need some guidance on what to purchase if so

Thanks Lester

[dragster73]

I though I had the ROM Images saved for this, but apparently I do not. I do have and EPROM burner and can make the chip for you if you can find the ROM Images.

[FuzzyDise79]

Thanks I seemed to have gotten past the start up and now I can't seem to clear the machine from the dot matrix showing "calling attendant" any ideas what could be triggering the attendant mode . Could it be the battery, door latch I looked through the manual and I didn't see any procedure for canceling it after also after sitting on for a while I closed the door and it went back showing the "rom sound 0" code again I left it sit.with the power switched off then it came back up and I was able to get into the admin/test settings again

Thanks in advance  Lester