need a WBA BV for an igt s plus slant top

[puckhead]

need a transport/head for a s plus. currently has a non working wba12

thanks
mike
516 662-3949

[ALIDMAN]

How do you know it is not working , have you tried reset chip for your BV first

[Shaggy]

Is this the same S+ as in the other post?

[puckhead]

same as the other post. my non working one wont even cycle. they cycle whether the BV is enabled or not.  mine show 9-1 in test mode, meaning the BV is enabled. is

[Shaggy]

same as the other post. my non working one wont even cycle. they cycle whether the BV is enabled or not.  mine show 9-1 in test mode, meaning the BV is enabled. is

But does the b/v WORK in the S2000? We need one that works to figure out what you need. If it works in the S2000, then we have someplace to start. If it only cycles there but doesn't work, then we still have to figure out what you need. Just because the head says WBA 12 or 13, doesn't mean the transport is a 12 or 13. Heads are all the same. Transports are different. Also S+ and S2000 use different harnesses. Not to mention software.

Dave

[puckhead]

9 the questionable BV did nothing in either machine. the good BV (from my 2000) works well in the 2000 and cycles in the s plus

[ALIDMAN]

I use DBV-200 in my S+ and works just fine it will take all the new bills even the new $100 ( without the strip ) . may be just use DBV-200 and use set chip to activate it

[puckhead]

to do that i'd have to change the frame and harness. a working wba will just pop in