1492 Ceronix for parts or repair

[Amechanic]

I'm looking for a video output board with a long ribbon cable as pictured. I'm setting up a Ceronix chassis for a Bally V2000, but the short cables too short.. I'm also looking for 1492 Ceronix chassis for parts or repair. Also looking for any Vertical Control Resistor Array "H" cards..

[drfreeze1739]

GOS  has 1942 boards that need repaired..

try contacting him..

[GOS]

i had the bad ones repaired by K-lar - they are for Bally - not sure how long the neck board cables are - will check on monday.

[Amechanic]

Thanks... I called Ceronix on Friday to order a few parts, only to find out that they didn't even have the parts listed on there web pages parts menus.. I'd like to find a couple of the "H" cards, new or needing new capacitors installed on them.. I'm working on building spare working tubes and chassis assemblies for Bally, IGT, and CEI.. I have the IGT done, need these parts to build the other too assemblies..

[Slotski]

Gary, if you don't get help from the others I have some repaired, used and possibly new Ceronix chassis but not sure what I have unless I check at the storage place. Let mr know if you want me to check. Gene

[Amechanic]

Thanks Gene.. GOS was going to see if he had the long cable video output board that hooks to the back of the monitor.. One thing that I forgot to ask for is the PCB that has the 5 adjusting pots for the monitors adjustments. Still looking for the H Cards.. When you get a chance to check, I like to know what you might want to sell.

Gary

[GOS]

have the pcb adjustment panel on ebay 152091849015

[Jim]

pm sent

[GOS]

sorry but all my ceronix has one size neckboard cable - not sure why you would need one longer?  The only monitors I have are a RGB from a V2000 not working and a Wells Garner touch screen from a game maker (works but has a scratch on the glass so keno type games won't register properly on it). I have the adjustment board for the cernonix as mentioned in an other response.

[Amechanic]

In the earlie Bally V2000 the chassis is mounted off to the side of the monitor instead of directly under the tubes neck. By having it mounted on the side, and the down word angle of the tube, makes the standard cable a few inches too short. Wells Gardner I believe was the factory setup, but I have seen then swapped over to a Ceronix chassis and different CRT like Zenith.

[Slotski]

Will do when I get out there. Do the H cards have a p/n stamped on them somewhere?

[Amechanic]

No I don't see any numbers on the one I have. They are located on the board to the left of the fly back, and right behind the center large heat sink. There usually is a small square Capasitor 10uf 16v right in the center of the H Card. The letter H is on the 1492 chassis board where the card is located.

[Slotski]

I will take pictures and send them to. I will try to get out there this week or Sunday at the latest.