Enable Printer SMLD Machine

[Slotsmanlucky]

 I need some help I purchased a printer for my SMLD machine and  I have keyed but can't printer enable.   When I key machine, printer doesn't give me option to enable.   I sure would like to get printer working so I can buy a TITO system from Jim for it.


Any help would be appreciated!


Thanks,  Richard

[777sizzler]

Richard,  Assuming that you have at least a 3.0 brain box and that you have A10114A09 operating sys. with AVPSB014B boot chips try the following.
Make sure there are No credits on machine
Intall e-Key 7
Select Set-up then Communication, Protocol
From my memory Port should read Comm1 and Adress -Adress 1
Hit next
Change serial to SAS1,  Hit Advanced and select Standard (For tito you use System)
Hit OK -Save and exit


Also in main device set up printer must be enabled.


Hope this helps B.


One more thing if it's a older operating system and boots other than what I stated other methods have to be used to set it up

[Slotsmanlucky]

Barry, thanks for of your help!


Richard

[Slotsmanlucky]

Barry, thanks for all of your help helping me getting my printer working, printer works great.   You when above and beyond helping figure out how to setup the printer!


Thanks Again! 


Richard

[777sizzler]

Richard,  You are welcome.  You got a complete rig and had questions so I helped-It's what I do.  B.

[Slotsmanlucky]

I just purchased another printer for my AVP 3.0 machine from Barry work great!


Thanks, Barry