S2000 BV Bezel install

[Caliwebman]

Hi all, wondering if anyone might be able to assist me in installing the bezel feed piece onto the bill validator. Thought that Spin inc. would have sent this installed already or at least with some instructions but to no avail I am left in the dark. I've considered taking a dremel to it and cutting out the black plastic on the BVG that's in the way of the bezel going on to it but it appears that the black plastic on the BV should come apart some how so I can then install the bevel and reassemble the BV. Any help would be appreciated! Pics attached.

Thanks,

[rjpohl]

You have to open the top of BV head before putting bezel on.  There is a release on both sides toward the front.  Release them both and raise front, then slide bezel on. 

[Caliwebman]

tHANKS, but can you show me precisely where these releases are? Cause I can release the top part out of the BV but still that does not give me the necesary clearance to fit the bezel in. Its as if I have to take the BV down much further. Is there a video around perhaps?

Thanks.

[rjpohl]

you can see them in your second pic.  there is one on each side in the top front.  Push them back and then raise the top up.

[Caliwebman]

Got it! Thanks a bunch!

In Appreciation,

scott