I created a small hack sometime ago. I hung led lights from the top of the cabinet into the open side of the reel baskets and put on a set of backlit strips.
I tapped into the power that went to the center basket stepper motor to feed a small relay so the lights were only on during a spin.
Now I do mean hack - this was steel tape (used for sealing heat duck tape to run the wires across the top of the cabinet, and a piece of stiff electrical wire as a guide to be able to take the lights down and position them in the reel basket. The reel strips were
[/size][/color]
non-matching to the theme that I had and I figured if this worked out I would have them made up.
I tapped into the power that went to the center basket stepper motor to feed a small relay so the lights were only on during a spin.
I was not overly happy with the results as the lights I had used were not bright enough, and while they came on with the spin they didn't "dance" - I think I would need to use a separate light controller for that. ie feed the light controller with power and have it perform light sequences or operate off of the sound. I also thought it would be good to have the lights come on (and dance) during a hopper pay but the voltages for the hopper motor are quite different than a stepper motor (and I think A/C) I never got around to playing with that.
The big thing is that there are only a few cross over themes where there are reel strips that would be compatible and while there are people who can easily print/laminate reel strips - the number of people who can do proper backlit are few and far between.
I tend to agree with the earlier recommendation - go native - don't hack the machine - buy a S2000 if you want backlit.