s2000 ram clear key set up

[timhays77]

when resetting this machine i'm only getting one amber light that turns on..  is this telling me something?


 this all started when my father in law unplugged the machine while it was on.


any help again would be appreciated.


I have fallowed the step i found on this site with no luck as mentioned above.  the steps il fallowed are below.


thank you.


S2000 RAM CLEAR/KEY SETUP 1. Power off slot and remove MPU tray 2. Remove SB chip and replace it with CLEAR chip 3. Power on slot and wait for top two amber lights to lite up 4. Power off slot and remove CLEAR chip and reinsert SB chip 5. Leave door open and power on slot 6. Should read “TESTING MEMORY” then alarm sounds with message error “RAM ERROR” 7. Turn RESET key four(4) times and it should read “PRESS TEST SWITCH FOR 2-3 SECONDS” 8. Hold MPU white button and release 9. LED now reads “CLOSE MAIN DOOR” Close main door completely 10.LED now should read “TESTING MEMORY” and when finished you get “CALL ATTENDANT” Message 11.Open main door and alarm should sound 12.Turn reset key 3 times 13.LED should read “MACHINE TYPE MISMATCH” 14.Power off slot and remove MPU and SB chip 15.Insert KEY chip 16.Power on slot and wait for two amber lights to come on 17.Power off slot—remove KEY chip—insert SB chip 18.Power on slot with door open and LED should read “7 KEY CHIP CONFIG”

[qbert]

You will need to set the machine up.
You need to set the machine to upright then set the denomination etc. etc.
Sounds like things were going well. Where are you stuck? What is showing on the VFD?

[RB]

when resetting this machine i'm only getting one amber light that turns on..  is this telling me something?


It would help to know what MPU you have & what clear & key chips you are attempting to use. The tiny part of your post is quoted above so others can actually read it. You are only getting 1 amber during which part of the process?