044 conversion with Door closure "L" error

[rslots]

Just converted a 19" machine to 044 and it is now looking for a closure on door "L" and don't see any other door switch wiring in the harness.  It is looking for closure of MBOL where M = main, B = Bill, O =  not sure what this is but have it currently jumpered so it is showing closed, and L =   don't know what this is.  Any ideas?  have wiring diagram for 044 mother board to see if it identifies another switch?  Machine was working fine as an 039.  Have converted other machines and have only had to deal with doors closures for M & B. 

[stormrider]

Just converted a 19" machine to 044 and it is now looking for a closure on door "L" and don't see any other door switch wiring in the harness.  It is looking for closure of MBOL where M = main, B = Bill, O =  not sure what this is but have it currently jumpered so it is showing closed, and L =   don't know what this is.  Any ideas?  have wiring diagram for 044 mother board to see if it identifies another switch?  Machine was working fine as an 039.  Have converted other machines and have only had to deal with doors closures for M & B. 

I had that error awhile back was the switch in the card cage
pull out the mpu you should see it,can't remember if I just disconnected it
or moved 1 wire over black or blue wire...sorry didn't write it down nor is the machine here.

Maybe wait until another member can confirm.
Tim

[GameKingSlots]

You will have to use a jumper on the backplane. (See picture attached) to get rid of the logic door error.

[rslots]

Jumper on he twp in connection on the backplane did it.  Much appreciated!

[stormrider]

Looked at the machine today I did not use a jumper
just moved 1 wire over
Looking at front of machine
Green wire on right post of switch
center post of switch left open
Blue wire on left post of switch

I would guess that putting the jumper on is like moving the wire over
either way glad the L error is gone for you.

I seem to be suffering from CRS these days.

Tim