WTB dbv-200-B123 Head and Transport 12V 1.0va

[Gavin]

Hi, I am in need of a tested and working head and transport. DBV-200-SS B123. The ID is 022/023 and I would be grateful for the latest update please. Going into an IGT S+ Triple Diamond (1996) Thanks so much for your help.


I should add that the SS is 6322 and the SP is 0932. Its a 5 Coin Multiplier Triple Diamond (217C) Type 0.


Tried everything to get the yellow bezel light on. Machine is set at 9...1 enabled. Also set at denomination of .25. Makes several 6 or 7 attempts to initialize then quits. No bezel light, will not take money. Checked all door swithches, proper can placement, optics, enabled, jammed debris, etc. No joy. Works fine with quarters, and all is well with the machine except bill validator. Has the newer power supply with cooling slots on the side. Dip switch 1 and 9 wer ON (in longer bank of switches) all the rest were off. I tried the machine with ALL switches off...no joy. Has two red lights on inside duck bill entry. Has two red lights illuminating on the  board on the left side of the head. Checked all connections as well. Frustrating... Maybe time for a working unit?  Thanks for your input and/or help procuring newer unit.

[Jim]

all the TEN (switch 10 will determine which protocol you are using) switches on the bottom should be off, this is for IDO 23 protocol.  the unit should make two distinct sounds during purge(power up) cycle. first is a heavy grinding noise, this is the cash can and transport cycling, the second is a lesser noise, this is the head gears cycling.  check to make sure the transport is seated all the way down and is in fact resting on the transport shelf.   next check the four pin connector on the right front side (no pins bent broken)  make sure two plugs on the left are inserted, front one is the power,  the one with two wires is the door bezel signal.  you can do a stand alone test and see if the head works,  remove the power plug on the left, turn the 200 head upside down, flip switch 6 (small bank of switches) to on, plug power plug in, now switch 6 off,  unit should cycle briefly, now you can insert bills into the head, if it is working it will take the bill in and send it out the back. (you do this test not using the transport stacker)  use only the head and the power plug.

Jim 

[Gavin]

Holy cow...phenomenal information! When I get home I will get to work on this and troubleshoot some more.
I am in your debt and will make another contribution, it is well deserved.


Thanks Jim


Regards,


Gavin