Bally Game Maker Ceronix LCD Screen updgrade problem

[mkraus01]

[font=]I just updated my Bally Game Maker with a 15” Ceronix touchscreen LCD.  Looks awesome and everything works fine except the touch screen does not work.  I tried the screen calibration and no matter what I try I can’t get the touchscreen to work.  It worked fine on the CRT that was installed prior to the upgrade.  [/font][font=&amp][/font]

[font=&amp][font=]I used the clear chip and reset everything.  I am not sure if I need newer software or if there is another issue?  [/font][font=]For reference, my mains are:[/font][font=]M0:  M1000C 0604-16[/font][font=]M1:  M4000C 0604-16[/font][font=]I have an email into Ceronix as well, but have yet to hear back.[/font][font=]Thank you[/font][font=]-Mike[/font][/font][/color]

[font=&amp][/font]

[Stayouttadabunker]

  We can't read half of your post.

[mkraus01]

I just updated my Bally Game Maker with a 15" Ceronix touchscreen LCD.  Looks awesome and everything works fine except the touch screen does not work.  I tried the screen calibration and no matter what I try, I cannot get the touchscreen to work.  It worked fine on the CRT that was installed prior to the upgrade.  I have several emails into Ceronix, but no response yet.

Could it be a software issue?  I can't seem to find any information on this upgrade, which is somewhat surprising.  Either no one has done it, or no one has had any problems except me :-)


My Mains are:
M0: M1000C 0604-16
M1: M4000C 0604-16


Any help would be greatly apprecitaed.
Thanks
-Mike

[Stayouttadabunker]

Show us how your touchscreen is hooked up on the back of the monitor....all the connections to the TS

[mkraus01]

The only connection to the LCD screen is the 24 pin connector on the bottom, just like on the CRT I replaced.  No other connections.