Paging OldReno, Need help on bally 1114 coin unit!!

[mrcrazy]

I have a bally 1114 Slot I need help with. I actually had 5 of these & got the other 4 going, this is my last one. Let me first say I am well versed in EM stuff & fix EM based pinballs & games & have been for over 30 years, I know my stuff. I have a 1.00 Bally 1114 that I went through top to bottom, & its now working perfectly EXCEPT the coin unit in the bottom right of the machine will NOT reset after it pays out one time. I have scoured this group & read a lot of posts with people who have the same problem, but still no luck. I replaced the rubber bumper, made sure my reset switch functions as it should, ohmed out the coils as well as tested them, but no matter what I cant get this to reset. It obviously steps up fine on the first pay, but it wont pay again unless & manually reset it.
Cant seem to find a manual with schematics to see what switch controls the reset. I have traced & ohmed out the wires as far as I can go, still no luck. IM STUMPED! it will do this no matter if its a 1, 2 or 3 coin payout. I have taken the coin unit out at least a few dozen times but no matter what I try I cant get it to reset.... any ideas? Anyone?
thanks in advance,
Greg

[GOS]

the "B" switch on the reel mech

[mrcrazy]

Thank you, I JUST watched a 2 hour long video Oldreno had suggested on a old post, & it addressed that issue. I will check that switch out tomorrow when I get to the shop & let you know my progress!
Again, thanks!
Greg

[wolftalk]

Let me first say I am well versed in EM stuff & fix EM based pinballs & games & have been for over 30 years, I know my stuff. ...
Cant seem to find a manual with schematics to see what switch controls the reset. I

yep, you just need the docs.  Look in http://bingo.cdyn.com/slots/


I think I have some paperwork for the 1114-6 also that I'll get posted in the next day or two. 


also look in the bally_manuals/ directory on the site.

[mrcrazy]

Just for future reference, it WAS the "B" switches which are on the left side of the reel mech going horizontally. Mine were touching but not making contact. Cleaned them & its now working all the way!!!
thanks guys!!
Greg