having an issue with the setup and a little stumped. After clearing the board and firing it backup with the sb chip installed, following the display to clear everything and it hits the call attendent. open the door alarm and back to clearing everything then when it initializes it comes up with "assert fail:martian.c @ 2149 -0x601" . I have gone through the wiring again and made sure everything is seated properly, checked the chips to make sure they are seated and the boards, all are seated well. The board in the enhaced with the varta battery removed, chips 577, sb100464, VS011GX1, DSPL0002, DSV00064.
Swapped out enhanced boards with my TDD enhanced that is working and has the varta battery(well had at the time), I had swapped over the daughter board that has the cips listed above. Swapped out each of the power supplies with the one I know works from my TDD machine. still getting that error.
of course now that I did that I needed clear chip my TDD board and set that machine backup and since I am new to this I am having issues getting the machine back to where it was working correctly. I was able to use the BV and printer and have a tito installed, plus multitouch on the machine. so I could use a walk through on re setting that up. caught one video on youtube that would have been great if the person was going through it a mach 10, but it did get the machine partially working correctly again. Now I have clear chipped it and ready to start the process all over on that machine.
the biggest thing is the error on the martian machine.