Hello to ALL, I have an S2000 with printer & hopper. I’m getting ready to install a TITO so I wanted to make sure these two items were functioning. When I took the glass out I noticed the printer was installed, but not hooked up, ( nice thing there was 3 more New ones in there as well). I looked at a couple of my other machines and on one went to the backplane & the other one went to a NETPLEX interface board, that went to the backplane. On this machine that interface board is missing. If I get that board and wire it like my other machine, do I just have to ENABLE the printer or are there other issues that need to be addressed? I want to have my split pay working and then I can install the TITO. Any help is always APPRECIATED, THANK YOU.