Originally a 1091 - Adjust reel position

[ThirdGenAmusement]

I am hoping to finish up on this slot.  It is a Summit system conversion of a Bally 1091.  Unfortunately the reels do not line up with the payout line on the glass.  The symbols are on top of the line but do lean lower on the right side.  Any way to adjust this?

[Amechanic]

Sounds like the strips have slipped in the reel tins groove. You should be able to move then by hand to the pay line.

[ThirdGenAmusement]

Sounds like the strips have slipped in the reel tins groove. You should be able to move then by hand to the pay line.

Thanks Amechanic.  I will give it a try. 

[DavidLee]

Reel strips just need to be realigned as Amechanic mentioned.

Check the actual reel shaft, it’s possible it could be shifted / adjusted.
The reels chassis guides might allow for adjustment or possibly some debris is stuck in one side of the guide.

Summit most likely made a new reels glass.
It might be possible to loosen the glass retainer and shift it to one side for a better appearance.
But, like they say if ain’t broke don’t fix it. Summit glass would be hard to replace.
Also reel glass in most cases have a cushion that adheres the glass to the frame.
Which makes it more difficult to move.