Help needed with belly light

[Wes]

Hello,
I

[erbs]

Please repost your question, using a computer. Posts with a cell phone are getting cut off.

[Wes]

Thanks for the heads-up erbs.  I actually did use a computer but let's try this again.
I

[Wes]

I was using copy+paste from a word document.  Maybe that's the problem.  I'll manually type it in this time.

I'm a newbie slot owner.  A few months ago, I purchased a RWB machine with a manufacturing date of 5/92.  I believe it to be an early S-Plus machine based on the information I have read on this forum.  The fluorescent bulb behind the belly glass is flickering so I would like to change it.  It appears I will need to remove most of the components in the door to gain access to the bulb since there is not a belly door (see pictures).  Any tips or tricks would be appreciated.  Thank you.

[Tilt]

Yes, it's an early model S+ machine.  It's easy to get to the bulb.  Remove the AC power plug and two screws circled in red.  Then pull the right side back some until you can move it to the right to get the tabs on the left side out of the door frame.  Replace the bulb and put it back together. 

Pic attached.

 

[Wes]

Thank you very much Tilt.  I appreciate the help.