WTB - Digitizer for 19" GK monitor

[stlscott]

HI I'm looking for the digitizer for my GK 19" screen.  It tracks poorly in the center region and I have replaced the controller and have removed and cleaned it, so it's a funky/bad digitizer.  Maybe you have a bad/dead screen that I could just buy for the digitizer?  I don't need the LCD part to be working.  In the picture, those were straight lines I drew to create the grid pattern using my finger, you can see how off/wrong the digitizer is.

[Tilt]

What are you calling the digitizer, the touchscreen panel itself or the touchscreen controller card on the back of of the monitor?  Also Digitech or 3M? 

[stlscott]

What are you calling the digitizer, the touchscreen panel itself or the touchscreen controller card on the back of of the monitor?  Also Digitech or 3M?

I swapped the controller on the back from a known good screen and that did not resolve the issue.  So I'm looking for the digitizer, the part that goes over the screen and connects to the controller, or a way to repair what I have???

[sixcardmark]

That IS the touchscreen itself. Be VERY careful removing it.

[Tilt]

Ok, you'll need a 3M touchscreen then. 

Check and make sure al your grounds are good starting at the outlet the machine is plugged into and the one from game cabinet to the game door.  That's usually a braided wire at the door hinges.  Sometimes a poor ground will cause his problems.  Looks for scratches on the touchscreen too.  Usually the touchscreen doesn't go bad without physical damage to it.

[stlscott]

Ok, you'll need a 3M touchscreen then. 

Check and make sure al your grounds are good starting at the outlet the machine is plugged into and the one from game cabinet to the game door.  That's usually a braided wire at the door hinges.  Sometimes a poor ground will cause his problems.  Looks for scratches on the touchscreen too.  Usually the touchscreen doesn't go bad without physical damage to it.

Grounds are all tight and checked, outlook is good, it's on a UPS.  Door ground is in good shape.  I can't see any physical damage to the touch screen.

[stlscott]

That IS the touchscreen itself. Be VERY careful removing it.

I used a wire that was previously used for removing cell phone and tablet screens, that's how I separated the touch screen from the LCD the first time to clean it.  Cleaning didn't fix it, unfortunately.   

[stlscott]

BUMP

Still looking for a digitizer for this LCD screen

[bud0143]

You might see if Get-t has it. They are out of Vegas

[Chris-socal]

I think I have a 19" LCD monitor with touch screen. I don't think the monitor works but I'm not sure because I don't have a power supply for it. I will look this weekend.

[Chris-socal]

Two pictures attached.
The first is a Wells Gardner 19” that is missing the controller but the panel looks good. I have no way to test. It has the same 5 pin connector as the 3M in pic 2 but it says TPK on it.  I have no idea if they are compatible.

Picture 2 is a working Kortek with a 3M touch panel. I really don’t want to sell the panel separately but I will sell the entire unit. I have seen the monitor work but no way to test the touch panel.

Let me know if you are interested in either option. I can send more pictures, no obligation.

Chris