Installation of Whales of Cash on Aristocrat MK7 USA Platform

[Bebra]

Whales of cash
USA Platform 3. 53.0-1.53.7
Linux OS 3.05.4

I have an Aristocrat MK7 with Pompeii installed, and I wanted to install Whales of Cash. However, now I’m facing an issue where neither Pompeii nor Whales of Cash is working. I couldn’t find any information on which PAR I need or the correct set chip. I have setchip with Linux OS 3.05.5 setchip 7.01.12.

I tried using it randomly, and now the machine just restarts and that’s it. When I attempt to reinstall Pompeii, it shows an EPROM error. I need help—could you please advise on what to do in this situation?

[hipistef]

Not much of an expert on the aristocrat machine, fairly new to the machine myself, I own 2 (double the punishment) but sounds to me like your setting are off for Whales of Cash, Your chipset should be fine for the Whales of Cash, from what I can tell it calls for 7.01.02 and your running the same series 7.01.xx. (7.01.12).    You might want to check the NLG File System there’s a chipset quick guide that would come in handy along with some other documents.

Hopefully someone will get you the proper par sheet set-up info…. for Whales of Cash…

As for the Pompeii game I have one, I’m using:

BaseX Multi
Multi demon
Var 99


Best of luck..

[Bebra]

Not much of an expert on the aristocrat machine, fairly new to the machine myself, I own 2 (double the punishment) but sounds to me like your setting are off for Whales of Cash, Your chipset should be fine for the Whales of Cash, from what I can tell it calls for 7.01.02 and your running the same series 7.01.xx. (7.01.12).    You might want to check the NLG File System there’s a chipset quick guide that would come in handy along with some other documents.

Hopefully someone will get you the proper par sheet set-up info…. for Whales of Cash…

As for the Pompeii game I have one, I’m using:

BaseX Multi
Multi demon
Var 99


Best of luck..

Thanks for the advice with Pompeii. I did everything as you said, and the errors are gone, but one issue remains: the static RAM didn’t clear, even though I used the set chip to clear it

[hipistef]

Did you finish your set-up through the Audit Mode?

Under …
Operator Setup/Selection….
Machine Options…
Device Driver Options