It was supposed to come with software already installed. I could not check it before bringing it home and the person I bought it through has been in business awhile. I sent them a message a short while ago and will probably hear from them tomorrow. I was hoping to get some information tonight if possible.
I just took the plastic off it tonight and found that I can not figure out how to open it. There is a single hole on the right and a place to put the reset key in. I tried putting my little finger in to see if there is a lever but I could not move it and I cannot see easily into the hole without moving the machine around.
Any help and suggestions would be greatly appreciated including anything to check/look at/be careful of etc. Thanks in advance.