Alpha S9000 Power Up Double Wild Rose 3 errors won't go away

[databig]

My 3 reel power up progressive keeps giving me 3 errors i did see PinJim's post I did replace all 3 batteries as RB mentioned i replaced the USB cable to the main cpu i pulled
both power supplies and cpu blew the dust off them, and any dust in the machine RCU seems to be working reels spin all fans are working machine was working fine then one day it just started spinning i do leave the machines on 24/7 unless a storm is coming also all caps look good no budge could a loose wire cause this? i reseated all plugins
Thanks for any suggestions it is very much appreciated

Pending Status
Mechanical Reels Not Configured
Lamp Projector Disconnected
7-Segment LEDs Disconnected

[rickhunter]

Mech reels not configured won't go away until you complete the setup (have you done that?).  The others are USB based.  There should be a USB cable going from the front door where the 7 segment display assembly has it's connectors to the backplane behind the reels (the reel's backplane).  Did you make sure this cable was good?  Also there's a power harness there.  When you power up, do the segment leds and leds inside the reel bezel light up? (usually this happens when you power up with the mpu power off).

[databig]

Thanks for your reply, Rick, yes i have done the complete setup probably 10 different times i follow Jim Saylor video setup instructions when i complete the setup having all
the progressive values correct and everything i try to calibrate the reels, but the screen won't give me the option after i hit diagnostic then calibrate reels, i have calibrated the reels before, so i am a little confused, (what is the lamp projector disconnected?) does that have something to do with the reels? (what is the 7-segment LEDs disconnected) is that the button panel, these errors are all new to me, I really want to thank you for your help i will change the usb cables out tomorrow and see if i can get it to complete the setup Thanks Mike

[rickhunter]

The 7 segment LED are the red LED numbers under the reel window, shows credits, current bet, lines bet, etc.  The Lamp projector are the LED lights behind the grey rectanguar bezel around the reel window that lights up during bonus stages and big wins as well as the LED's that light up the reels and flash different colors based on game activity.  Both of these are controlled by the USB cable that connects to the assembly that is attached behind the reel glass.  If there's a problem with this assembly, neither of these things will work and you will get the tilt error you are getting.  So you either have a power issue (which you can verify by powering up the cabinet with the mpu turned off, all the lights in the front should light up), you have a USB cable issue, or the reel backplane is faulty.

[databig]

Thanks, I will do some checking i have new usb cables coming