Looking for IGT door hardware.

[Keats]

7/13/26
IGT Game King round top Ser # 1717145,  IPP# I1444574.  I beieve that it's a S + machine but it may be an I + because it's a video poker machine. I'm not sure.

I've had this machine for about 10 years and it works very well. I usually load the machine with credits via U.S.C. and after I pass the bills thru the bill acceptor, I open the door and remove the bills to add them back in again for additional credits.

This machine was modified some years ago - before I bought it - and a flat plug was installed on the side edge of the main door where a lock should have been. That's not really a problem, this is for home use only.
There is no way to release the belly door either. On my other machines, there is a small spring loaded knurled knob on the side of the door near where the door lock is located. By pulling the knob. it moves a bracket that secures the top edge of the belly glass and allows the belly glass to drop down to access the lamps, wiring, and the bill acceptor cash box.

Opening the belly door would make removing the bills much easier and quicker.

My machine's belly door can open if I open the main door and release a small latch by hand and then push the locking bracket to the left. The belly glass will then drop down. I can access the cash box and reinstall it again when emptied and close the belly door.

I've searched all of the paper work and a CD showing maintance instructions and the best I can find is a Belly Door Locking Bar part # 639-079-00 and there is also a spring loaded Pin Plunger that may be the knurled know pulled to release the locking bar and it's part # is 444-099-00. It's not shown on any diagrams.

I'm not sure that these are the right parts ...

So does anyone know the part number for the Pin Plunger and the Small Bracket it secures on the Belly Door Locking Bar.

I also would like to be able to lock the main door, so I'd need a lock (ace key ?) to function a cam lever to prevent the door from opening.

Any help would be appreciated.

Will try to shrink my photos to smaller size the load here ASAP.

Keats
Peoria, Az

[shortrackskater]

It sounds like you simply have an I Game, not an S plus. Moving this to NLG Classifieds.
It would be great if you can post ONE photo of the entire machine and perhaps a couple more showing the location of parts you need.

[Keats]

That's possible.
I tried to look up the serial number to see if it would classify it but no success...

I tried to reduce the size of my photos and so far I'm not having any luck. Each is larger than the upload allows.

I'll keep trying.

Thanks,
Keats

[FireballJackpot]

- Load your pictures on to your computer (Windows)
- RIGHT click on the photo and click EDIT or Open (or EDIT) With PAINT
- Upper left corner in Paint; Find RESIZE in the upper left corner and select 40%. Then SAVE

That should get the photo BELOW 1 Meg (999k or less)

Hope this helps!

[Keats]

Thanks.
I actually use an MacPro. Laptop. Should work the same way.
Keats

[shortrackskater]

https://www.shutterstock.com/image-resizer