Looking for BallyE-Series led ribbon cable AS-2988

[Caliwebman]

Hi there, have an ole crusty E-Series that the LED is out on... further inspection would suggest the ribbon cable melted  a little bit.  So I am looking for a custom flat/ribbon display cable used in Bally E-Series (E-1000 and E-2000) electronic slot machines. It connects the main processor (MPU) board to the AS-2985 LED display board assembly. The part No. I believe is Bally E-Series led ribbon cable AS-2988. Any help would be appreciated!

Scott

[cliffeby]

I have a cable connected to the six leds.  The first led does not work.  I believe it's the led not the cable but haven't tested it.  I found that that the first led position is not as necessary as the others.  $20 + shipping if you want it.

[Caliwebman]

Thanks for the reply CLiffby. Even though the cable looked slightly melted I took a multi-meter to it and cannot believe its continuity checked out; amazed. Am wondering if you might be parting out an e200 per chance? I think someone did a number on the hopper on this one, and in an attempt to fix it I am afraid they bent bolts and basically made it non functional due to a major jam. Have you by chance a hopper for sale? If not does anybody know where to get a Bally E-series 2000 hopper? We may be needing additional parts too. All help very much appreciated!

Scott

[cliffeby]

I have a working hopper.  Tried to reply and NLG Failed.  If this goes through, I try to rewrite full message.

[cliffeby]

Very small pic

[cliffeby]

As shown the one reset switch is bad.  Replaced it with a contact/roller switch and it works fine.  You can easily swap in your board if preferred.

I'm not sure if I am supposed to post this in Classifieds.  Same $20, but shipping will be higher.  Probably best to DM me if interested.

[Caliwebman]

Hey Cliff, I want it for sure as per the hopper... can u please just call or text me... getting hammeered with spam calls so texting at first might bebest. thanks - scott 4084177205