Draw Poker United Gaming Inc. With CEI 906 III and 911 mother brd

[wkwgold]

My first post, so PLEASE bear with me.
I just got this machine, the person said it worked, just no picture (sure). When I powered it up I had no lights .The monitor fuse wires on the cont box had been moved to the motor fuse because the monitor fuse was broken. I put in a req fuse holder and put the wires back where they belonged, still no lights. I checked the AC voltage to the florescent lights and the monitor and it was around 59V AC. My line voltage is 112V, at the on off SW on the cont box it is 112V. I traced the wires to the mother brd and everything seem OK. I also metered all the fuses and they seem OK.
I think if I had a wiring diagram of the Cal-Omega 911 mother brd I could figure the problem out. The only wiring diag I found on this site showed the wiring dia for the control panel for a Santek? and it didn't match the wiring of my control panel to the 911 mother brd.
The 12V and 5V leds on my mother brd are on, though I'm not sure if the voltages or correct.
THANKS for any help.
PS No game sounds led on 906 brd not lit

[wkwgold]

Knock Knock  anyone there? Some views, no help. ANYTHING would be helpful.

Thanks Walter White wkwgold

[wkwgold]

Ok got a PM from slotslots about the 110-220 sw on mother brd. I did check and it is set on 110V. I will check it again. The mother brd is hard to get out and have plugged in. If anyone has a wiring diagram of the CEI 911 mother brd, that would help.
Sorry slotslots I couldn't figure out how to reply to a PM. It does make scene that half the AC is missing, But where.
THANK YOU for a reply, like I said ANYTHING will help.

[shortrackskater]

Hang on. There's people here that might be able to help! 
Let me see if I can dig one out of the woodwork.

[doyson49]

here is a patched together 911 mother board schematic
hope it helps
doyson

[wkwgold]

Thank YOU! Thank You!
This will help a lot! It's going to be a couple of days before I have time to work on it again. But I know this will help me find the problem. I will let everyone know what I find.
Thanks again,
Walter White wkwgold

[wkwgold]

Well, I finally got the print blown up and printed out. Got to the slot yesterday.
I guess I get the GOOF OF THE YEAR award!!!!
What kind of switch SHOWS 220V when its set a 115V and shows 115V when its set on 220V??
YES after looking at the wiring diagram and tracing the print on the mother brd, I found I had the sw set for 220V!
I now will fix the monitor, a Ceronix 1492, no HV, shouldn't be to hard.
Right now when I drop a coin it spits one out of the hopper. Also when I push a button other buttons light up.
All problems that should be better seen when I get the monitor fixed and can see what it says on it.
Thanks for the help so far!!!!
Please stay tuned, I feel I made need more help!!!

[shortrackskater]

Good to hear! Thanks for letting us know. We'll (well at least two of us) will be standing by.